CARVECASTListen in ↗
← Back to ski gear

BOOT LINERS / MY GEAR

ZipFit Gara LV liner

My Gara LV setup and why I look at it separately from the Corsa.

Putting on my ZipFit Gara LV liner over a heated sock
Still from my own video

Where you can see my pair

I show the Gara LV in my ski boot get-ready film with the Salomon S/Pro Alpha C BOA 130, a Moxxis insole and heated socks. The clip is a better introduction than a photo of the liner on a shop shelf: you can see the actual combination I was putting on to go skiing.

Why “LV” matters

ZipFit describes the Gara LV as its lower-volume Gara with less cork than the Gara HV. I’d think of that as a starting point for fitting, not a number you can use to order blind. The shell, footbed and sock all share the same space. When I put a heated sock into the setup, I want it lying flat and I want enough room that the foot still feels the way it did at the fitting.

Gara LV or Corsa?

These are separate setups for me. The Gara LV is the one I identify in the get-ready video; the Corsa is the very thin liner I discuss after the shell size change with Tim. The Corsa starts lower in volume and is aimed at very close performance shells. I would try the Gara LV if the shell calls for that kind of low-volume fit without assuming you need the closest race fit available.

How I’d decide

Bring the shell, footbed and actual ski socks to a fitter. Try flexing the boot before tightening everything hard and check whether the heel stays in place. If you feel a pressure point, describe exactly where and when it happens instead of immediately adding cork around it. This is a setup I use and rate, but the value is in getting it properly fitted to you.

My Gara LV ski boot get-ready film

Watch, listen and read more